michaesullende0 sur eBay

À propos

Lieu : États-UnisMembre depuis : 16 mai 2017

Évaluations

12 derniers mois

Positives0- évaluations positives au cours des 12 derniers mois

Neutres0- évaluations neutres au cours des 12 derniers mois

Négative0- évaluations négatives au cours des 12 derniers mois

Toutes les évaluations (100)

blairtg (77274)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Thanks for choosing BlairTG! Great Transaction! Enjoy your item!!

Afficher toutes les évaluations

Avis (4)

1000 PCS LED 5 mm Blue light Transparent LEDs Diodes Y2T7

12 janv. 2018

Very good, very bright, and quite durable.

I thought i was gonna get screwed over, but I didn't. VERY good deal. works as described.

ATmega328P CH340G UNO R3 Board + USB Cable Compatible with Arduino LW

01 janv. 2018

It works?

What do you expect? It's a CH340G based CLONE of an Arduino UNO R3 For anyone who isn't familiar with these or Arduino in general: The genuine UNO uses the Atmega8U2 as a USB driver to create a virtual serial port(COM4, COM6, etc), These cheap Chinese clones use the CH340G in place of the Atmega8U2, that is NOT usually a problem for most people, and in fact I've had a much better experience with the CH340G in programming specifically, applications I create to communicate with my Arduino based projects have much better luck whereas the Atmega8U2 will give me trouble and sometimes requires addition steps to be taken to make my applications compatible, the CH340G has also proven to me to be a faster solution. However one slight drawback is the surface mount MCU package, in my genuine Arduinos i can simply place my Atmega328p DIP package onto a hand-etched or proto board with the DIP socket soldered in place, this is not possible using these UNO clones, which is not a huge deal but will definitely limit your options if you intend to make a lot of stand-alone devices. Thankfully you can solder some extra male headers to the bottom of the clone to fit it on a protoboard with a little rigging, or just make a male-female R3 compatible socket to plug the entire board into. For the most part, you can use it in place of a normal Arduino UNO R3.

2 personnes sur 2 ont jugé cet avis utile.

NETGEAR 8-Port Gigabit Ethernet Switch (GS208) 606449104516

31 juil. 2017

Not bad for the price

Fast enough for basic home networking, but unlike other 8-port switches, it literally only has 8 ports so you can only connect 7 devices(because one most be used to connect it to your router or another switch with an internet connection) Other than that, no problems. Just a bit misleading.

1 personnes sur 2 ont jugé cet avis utile.

Afficher tous les avis