grti.us.qd3jih3190 sur eBay

À propos

Lieu : États-UnisMembre depuis : 21 sept. 2014

Évaluations

12 derniers mois

Positives55- évaluations positives au cours des 12 derniers mois

Neutres0- évaluations neutres au cours des 12 derniers mois

Négative0- évaluations négatives au cours des 12 derniers mois

Toutes les évaluations (344)

carpartsshippedfastllc (5173)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Good buyer, prompt payment, valued customer, highly recommended.
centralpafiltersupply (1197)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Thanks for buying from CentralPAFilters!!
micsca-984 (445)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Great buyer smooth transaction. Thank you for being a repeat customer. Thank You
powersl*tracing (14687)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Great communication. A pleasure to do business with.
xbdx75 (1292)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Great communication. A pleasure to do business with.
istore-net (15066)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.

Afficher toutes les évaluations

Avis (17)

JZBRAIN 8'' Center Commercial Faucet Wall Mount Kitchen Faucet with 14 Inch

29 avr. 2020

Good

I bought 2 different types of faucets. Both types had rubber washers in the areas where they needed secured to the sink. It was difficult to tighten properly without over tightening and alignment of the fitting towards the pipe. They should have been designed without the rubber washers in these areas and use only pipe dope or Teflon tape. The design would lead to possibly leaking in the future due to the initial overtightening or undertightening. Eventually I butted the fitting up against the rubber washer and held the fitting with pliers while tightening the brass nut up against the sink surface.

Estwing E-5 Sure Split 5 lb Splitting Wedges

18 janv. 2025

I have been using standard metal wedges ...

I have been using standard metal wedges on wood for years. They always seem to lack that last little bit of spread to split the wood. I can tell just by looking at this one that when that 20lb sledge hammer hits it, that extra width from the wings on it will make a very big difference! I've been using a slate bar to finish prying the wood apart, which is a very big help. I won't be using that bar as much now. Just finished a 4ft diameter white oak and wish I would have found this style before.

(35) Hex Head 1/2 x 4 Lag Bolts Galvanized Wood Screws

09 févr. 2019

great for my project

excellent as described in the ad

Afficher tous les avis