glynnhill sur eBay

À propos

Lieu : États-UnisMembre depuis : 01 avr. 2001

Évaluations

12 derniers mois

Positives3- évaluations positives au cours des 12 derniers mois

Neutres0- évaluations neutres au cours des 12 derniers mois

Négative0- évaluations négatives au cours des 12 derniers mois

Toutes les évaluations (195)

blinglights-central (1369)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Good buyer, prompt payment, valued customer, highly recommended.
rlpartssupply (28621)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Hope to deal with you again. Thank you.
mrsreporon (43176)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
whd-parts.com_for_low_cost_parts (3682)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Awesome eBayer! Would leave 5 stars if I could Any questions Call 1-204-981-9138
bohemianclass (200)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Quick payment!
gregthree (36081)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Thank you for an easy, pleasant transaction.Excellent buyer. A++++++.

Afficher toutes les évaluations

Avis (9)

Dorman 615-188 Intake Manifold Plastic Stock Replacement Base Ford 5.4L Each

14 sept. 2016

If it holds continues to hold up it is a good value, of course it is plastic same as the stock oem but there is some major differences between the two

On the stock oem intake the mounting points for the coils, fuel rails, cruise control and anything else that mounts to the intake have threaded metal inserts to bolt into. The Dorman does not have the metal insert and utilizes a self tapping style screw to secure the item to the intake. Dorman however does supply these supposed specialized screws. The underside "volume tank" on the Dorman is much smaller than stock as well which allows for the exemption of the heat shield on the stock manifold. The truck does run good and does not leak coolant so it does serve its purpose. it is a good substitute for OEM factory but feel it could have been better. Just my two cents worth. Would I recommend it? At this time yes but will point out the differences from it and the stock intake.

1 personnes sur 1 ont jugé cet avis utile.

TANDEMKROSS Magazine Disconnect Hammer Bushing for Ruger Mark III 22/45

08 févr. 2017

Absolutely worth it! Makes it easier to clean and reassemble

I first took down my Ruger MKIII to clean up any "wire edges" on the internal operating parts to make the trigger better. Trying to get everything back together was a pain. But the trigger was improved drastically. Once I removed the Magazine Disconnect and installed this bushing the trigger worked even better and smoother. Now the gun can be fired with the accuracy one would expect from this type of gun.

Ghost Inc. Edge 3lb Trigger Connector for Glock 42 & 43 - G42 / G43

14 oct. 2016

Ghost inc

Highly recommended

Afficher tous les avis