dkotsop2016 sur eBay

À propos

Lieu : États-UnisMembre depuis : 12 juin 2016

Évaluations

12 derniers mois

Positives2- évaluations positives au cours des 12 derniers mois

Neutres0- évaluations neutres au cours des 12 derniers mois

Négative0- évaluations négatives au cours des 12 derniers mois

Toutes les évaluations (79)

drillman1 (30829)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Prompt payment - thank you very much.
*****- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
*****- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Quick response and fast payment. Perfect! Hope to deal with you again. Thank you

Afficher toutes les évaluations

Avis (2)

(10) 0.30mm (.0118") 2 FLUTE MICRO CARBIDE ENDMILLS Kyocera Tycom

05 janv. 2017

Very Pleased!

I purchased these endmills for milling PCB's. Up to now - I have been using V bits (0.1mm 10, 20, 30 degree) and have not been pleased at all. V bits tend to leave burrs and a rough finish so sanding is required to get a smooth finish. I tried using these endmills (replacing the V bits) and the finish is absolutely perfect! No burrs or sanding needed. Cuts are very smooth and accurate. I would strongly to recommend these endmills for any kind of PCB work.

1 personnes sur 1 ont jugé cet avis utile.

3 Axis CNC USB Card Mach3 200KHz Breakout Board Adapter For Stepper/Servo Driver

31 août 2016

Great Improvement!

I ordered this USB card for my 6040 CNC machine which already had a parallel port type breakout board installed. The card comes with an mini CD containing the installation manual (PDF), an updated driver for the card, and a copy of MACH3 software (not sure if its simply a demo version since I didn't use it). The installation of the card is very straight forward as it was well explained in the manual - I had no problems what so ever. I took advantage of the extra outputs and use them to control mist, coolant pump and best of all - spindle motor control (on/off, FWD, REV and speed control). I immediately noticed a big improvement on the smoothness of the stepper motors. Everything seems far more precise probably due to the increase frequency of the USB port (200kHz) in comparison to the parallel port. Another positive about the card is that it runs from a USB port and with windows 7 - no need to look for an old computer that has a parallel port and XP operating system. Overall, I highly recommend this card due to its ease of installation and improvement over the common parallel port type breakout boards.

1 personnes sur 1 ont jugé cet avis utile.

Afficher tous les avis