deep_dolphin sur eBay

À propos

Lieu : États-UnisMembre depuis : 09 avr. 2001

Évaluations

12 derniers mois

Positives86- évaluations positives au cours des 12 derniers mois

Neutres0- évaluations neutres au cours des 12 derniers mois

Négative0- évaluations négatives au cours des 12 derniers mois

Toutes les évaluations (1 264)

*****- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Good buyer, prompt payment, valued customer, highly recommended.
newteckcity (6990)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Good buyer, prompt payment, valued customer, highly recommended.
thrift.books (3879655)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Great communication. A pleasure to do business with. ~Thrift.Books
second.sale (4086139)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Great communication. A pleasure to do business with.
reliantbookstore (37384)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Quick response and fast payment. Perfect! THANKS!!
worldofbooksusa (1167961)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.

Afficher toutes les évaluations

Avis (28)

2 Compatible BROTHER P-TOUCH TZ-231 TZe-231 12mm 1/2" LABEL-TAPES BLACK 2

05 févr. 2016

Just as good as OEM

Just as good as OEM tapes and inexpensive enough where the cost does not prohibit their use.

Mahr 4308950 800 SDZ Puppitast 0.0001" Lever Indicator 0-4-0

14 déc. 2022

For Spindle run out. Made in Germany.

Excellent indicator for measuring spindle and collet run out. Made in Germany by free people.

Needle Tipped Tip Multimeter Probes Test Leads Tester 1000V 20A 90cm Cable Long

20 avr. 2017

Perfect for small electronics. Not safe for mains voltage.

Perfect for small electronics. Not safe for mains voltage. Because most test leads sold today are the same design used last century for vacuum tubes and point to point wiring. These are the most perfect no compromise leads for surface mount components. The ends are only 2mm in diameter and 21 mm long. Most test leads are bulked out with Cat 3 insulation and are impossible to get down into the small stuff. The plug ends are at a 45 degree angle which is so much better than a sharp 90 degree as it allows clearance for the meter dial ... you sorta' have to see it to understand. --- These do need the end shafts covered with heat shrink to leave just the points so you do not end up shorting them together. Most important when measuring Voltage on a LiPo battery charging connector. While these are stamped with CAT 3 rating, because of the large exposed tips, even with heat shrink, I would not consider these safe for mains voltages. And do keep these away from LiPo batteries until you heat shrink cover the exposed shafts.

1 personnes sur 1 ont jugé cet avis utile.

Afficher tous les avis