The Bersa BP Series is a great gun with a small, slippery grip. IMO, This grip tape is the most important modification you can make. I filled out the palm swell area with 4 diminishing layers of duct tape under the grip, and the was able to cover it well.
There is not enough material to adequately cover the back strap, you may want to cut some tape from a bulk pack (as I did) to get better traction in the back. Then heat the tape, mold it into the grip while warm, and let it cool. After several weeks of carry and one shooting session, It has not budged.
New OEM Moshi iGlaze Napa Premium Black Case For LG G4
05 sept. 2022
Nice Quality in an Impractical Design
Very nice quality, good fit, and the leather on the back is classy. Unfortunately, the edges are made of a slippery grey plastic, and this is the part of the phone that we handle the most. Nice design, but not very well thought out or tested.
Handlebar grips for handlebar heating for BMW R1200 GS S R RT S1000R RR
20 avr. 2022
Solid, Small, Need a Little Mod for Correct Fitment.
These grips are for BMWs with heated grips, so they are the same inner diameter (26mm) on each side, and won't work on regular handlebars. The throttle grip is the correct length for an R1100RT, without an over-large gap or dragging on the ends. The rubber is tough and tacky, and the installed grip has a smaller diameter (32mm) than the stock grips, which I prefer with my size 8 hands. If you have big hands, they may feel small to you.
The right grip is plug'n'play, but the left grip does not have the "cutout" for the metal ring on the inside of the left grip near the switch assembly - so unless you want that ring to be visible, you'll want to hone out a little of the inside of the grip to fit over the ring. I found a Dremel with a sanding wheel completed that job in less than two minutes.
If you spray the inside of the grip and the heater surface with brake cleaner and then quickly slide the grips on, it activates the glue on the heater, creates a strong bond, and you won't get any grip glue under the throttle pipe. Just be sure you've got the right grip in the right direction, because once you spray, you've got about 10 seconds before the grip starts sticking to the surface, and then it's really hard to get it off for a do-over without destroying it.