asnmlt3bpd sur eBay

À propos

Lieu : États-UnisMembre depuis : 23 déc. 2000

Évaluations

12 derniers mois

Positives4- évaluations positives au cours des 12 derniers mois

Neutres0- évaluations neutres au cours des 12 derniers mois

Négative0- évaluations négatives au cours des 12 derniers mois

Toutes les évaluations (111)

ausgeknipst (12410)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Bin gerne zu weiteren Geschäften bereit. Danke.
goodwill_industries_of_san_francisco (322469)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Your generous support creates jobs and transforms lives, thank you! Goodwill SF
bistatesales (34197)- Évaluation laissée par l'acheteur.
Six derniers mois
Achat vérifié
Hope to deal with you again. Thank you.
warlord9mm (6897)- Évaluation laissée par l'acheteur.
Dernière année
Achat vérifié
Thanks 4 the kind feedback. Super fast payment. Xclent Transaction. Great Buyer. Thanks. A+++
southeast_irrigation_supply (2387)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
genepart (652)- Évaluation laissée par l'acheteur.
Il y a plus d'un an
Achat vérifié
Hope to deal with you again. Thank you.

Afficher toutes les évaluations

Avis (2)

INTERMATIC Timer Trips for POOL replacement trippers trip T101 T104 heater

08 mars 2016

Intermatic timer tripper

These trippers work. Good quality. The original intermatic hex head screws were easier for me to lock them in place. However these trippers work well.

Supco RIM597 Replacement for Whirlpool 2198597 8 Cube Icemaker

02 déc. 2020

Kenmore Coldspot icemaker replaced with aftermarket icemaker.

The icemaker in carton box arrived undamaged. Look on youtube for removing the old icemaker. Pay attention how wires and connector are positioned when the wire shroud is removed. Remove the old white plastic shroud and use the same 3 screws to mount it on the new icemaker. Note: the new icemaker has a scew for a clamp over the heating element which must be removed. The new wires and connectors fit well. Install the new icemaker. Push the wires and connector back so that the icemaker can be pushed in place. Cover the wires with the old wire cover. We tossed the first bucker of ice cubes as one is not sure how clean the new cube trays were. We checked the old icemaker. The defect was located between the copper trace contact fingers and the heating element pin. The fingers lose their contact pressure over time and eventually result in arcing and complete loss of contact. The icemaker water supply line tip and the hopper freezes and no cubes produced.

Afficher tous les avis