Avis sur le produitNcSTAR Nc Star VR30H09 Hunter Rings, 30 mm/0.9

Best maintenance practice

The NcStar rings are very well made. However, the ring screws should be a hardened type of fastener. 25" lbs is the standard torque. These screws maybe metric ? Without being too much of a pain, you may need to re-thread ring inserts. Standard screws might be 6-48, 8-36, 8-40. Leupold or Badger screws are available, may require drill bit & tap. These will now be stronger than a suspension bridge. You can turn scope mounting into a fine science by lapping & bedding the base & mounts. Just don't drop it.Lire l'avis complet...

Achat vérifié :  Oui | État : neuf | Vendu par : wellskargo

Ruger American

If you are mounting a 30mm scope with 50mm objective on a Ruger American short action, these will work, however, you will need to file out the groove for the rings to fit the bases or buy bases. So far so good, scope bell is 3/16" above barrel,Lire l'avis complet...

Achat vérifié :  Oui | État : neuf | Vendu par : extremetronic

solid built

fits both 1" and 30mm scopes. easy install.

Achat vérifié :  Oui | État : neuf | Vendu par : wegotbetterdeals

Just right

I’ve been dusting the Vism rings for roughly 10 years now for mounting optics on long guns. They are reasonably priced and hold up well for most of my mounting needs.

Achat vérifié :  Oui | État : neuf | Vendu par : opticscamp

If you just remember there's no need to over tighten scope rings you'll be happy with these.

Achat vérifié :  Oui | État : neuf | Vendu par : extremetronic

JUNK

I'm No Novice at mounting scopes, and have used several aluminum rings thread pulled out way before torque specs were reach waste of money, waste of time, Not even worth the return !

Achat vérifié :  Oui | État : neuf | Vendu par : extremetronic