5étoiles
6évaluations4étoiles
1évaluation3étoiles
0évaluation2étoiles
0évaluation1étoile
0évaluation
Would recommend100% J'accepte
Good value85% J'accepte
Good quality100% J'accepte
6 avis
Well worth the money.
this has taken out a MASSIVE load of work for me. Now I only have to tune the bed level once and can make very small alterations on the fly as I print with different materials.
Achat vérifié : Oui | État : neuf | Vendu par : sovol-3d-printer
Plug and Play if your 3D printer has a boot loader.
Installed on CR-10 with Creality V1.1.5 board. I used the firmware from TH3D. Due to memory limitation of 8-bit board, the Gcode and LCD support are limited but BLTouch works great still. The best thing is, the kit provides the extension cable and one extra BLTouch probe pin. That will save you money to buy later. Even you have CR-10 V2 or Ender 3 V2, you still can use this kit with 3rd party firmware (I guess Creality firmware with BLTouch for these V2 printers will need BLTouch V2 kit because of the extension cable they provide). By the way, I didn't use their ISP burning tool because the Creality V1.1.5 board already came with a boot loader. Therefore, you can just flash the firmware using Arduino IDE with USB cable.Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : sovol-3d-printer
Which I had purchased the Original in the first place!
Tried two other alternative equivalents, but the resolution was too poor to be useful. The original BLTouch worked immediately and consistently after installing. Even if your bed is level and stable, the BLtouch used as the Z homing device makes for print bed support changes a snap. PEI to glass to other, no changing the bed leveling wheels, the BLtouch will home to the height of each bed. Worth the money just for that feature!Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : dustandlight
Good upgrade for Ender 3 Pro
If manual bed leveling is a PITA, then consider an original BL Touch ABL. Be sure to check your main board serial number to get the right upgrade. After some tweaking of the firmware and Cura settings, printer works like a champ!Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : southernbellesn...
Works, but not really needed.
I put this on an Ender 3 V2.
Easy install and works as intended. But ................ If you have a flat bed, like a glass one, it really isn't all that useful. Do a proper bed level (that means don't warp the glass with one corner spring too tight) and you won't need one of these toys. I suppose it might save a print if I bump something and don't notice?
A glass bed should only have 3 level springs/screws.Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : creality3dvip
Great product
Works great on my Sovol SV01
Achat vérifié : Oui | État : neuf | Vendu par : hotsaleshop-03