5étoiles
43évaluations4étoiles
5évaluations3étoiles
2évaluations2étoiles
1évaluation1étoile
0évaluation
Would recommend100% J'accepte
Good value100% J'accepte
Good quality100% J'accepte
37 avis
Excellent quality, great price and service
These Japanese high quality Omron switches replace the Uline microswitch UL2506 which is no longer available. Perfect fit, operation and performance.
Achat vérifié : Oui | État : neuf | Vendu par : pipestoneusa
Quality switches
All switches arrived as ordered in perfect condition. Continuity cheched each switch and all worked perfectly as well. The switchs are stiffer than the ones I replaced, but feel they are more heavy duty. Has "Made in Japan" on them though they are shipped from China. Would buy again, but no need to with 10 switches!Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : huayi-components
Easy replacement for the microwave door sensor
This micro switch has two outputs and can be used if you only need one, old micro only had one near the bottom and this one matched it so I covered the one not used. Best price unless you need multiple switches.Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : steve48348
Failed in under 3 years
I installed three of these switches in a microwave oven. The problem was with the control board but I changed the switches just in case. One failed mechanically: the pin sunk in and was stuck. Disappointing, especially for "Made in Japan" label. Perhaps this was due to a wound wire spring used in the design (see the drawing in the data sheet). Went back to the original switch which was saved.Lire l'avis complet...
Achat vérifié : Non
Good switch but not for me.
A very good quality switch, however the device did not work for my application. The amount of force needed to snap the switch exceeded the weight of the float device in my washing machine, even with a lever.Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : steve48348
Good product, good price.
Good product even better than the original one I had before, and arrived in time.
Achat vérifié : Oui | État : neuf | Vendu par : steve48348
Great deal!!!
Exactly what I wanted. I needed a normally open phase but it also had a normally close leg on it for either state.
Achat vérifié : Oui | État : neuf | Vendu par : steve48348
Perfect
I used this on a Sears angle grinder trigger, could not get one from Sears, got this one and it worked perfect!!!
Achat vérifié : Oui | État : neuf | Vendu par : steve48348
Craftsman grinder switch replacement.
Worked perfect on my Craftsman grinder. Ever plug your 7 1/4” grinder in and it starts without pulling the trigger? The start up torque will jerk that tool right out of your hand if you try to plug it in with it stuck on. Lire l'avis complet...
Achat vérifié : Oui | État : neuf | Vendu par : steve48348
Exact Replacement for the OEM OMC and Morse binnacle throttle neutral switch. Saved almost $15.
Achat vérifié : Oui | État : neuf | Vendu par : steve48348